Filter
Top Products
EN
Advanced Operation
8
General Operation
9
DSP
• Press repeatedly to select among the
DSP modes:
FLAT > BASS > POP > ROCK > JAZZ
• During playback, press and hold DSP
will show song title, artist, format and
bit rate on display.
Play modes
• Press MODE repeatedly during play-
back to switch among the following
playback modes:
Normal playback > Repeat All >
Shuffle > Shuffle repeat >
Program > Repeat program >
Normal playback
Note: Program and Repeat program will
only appears if there are programmed
tracks.
Programming Tracks
1. Press and hold MODE for 2 seconds in
stop mode to enter program mode. You
will see ‘P’ icon lit representing program
mode, flashing ‘ - -’ for track selection
and ‘P01’ for program list position. (If
you have program in your player, the pre-
programmed track number will be
shown.
2. Press Skip backward or Skip for-
ward to select a track. Selected track
number will flash.
Note: The player will enter Intro Play
mode and play the beginning of each
track as you scroll through tracks for pro-
gramming.
3. Press MODE to confirm selection.
4. Press MODE again to skip to the next
programming position.
5. Repeat steps 2-4 for further selections.
Maximum 20 selections can be made.
6. Press STOP to exit programming mode
or unit returns to stop mode automatical-
ly after 30 seconds if there is no key acti-
vation.
See section on “Play Modes” to playback
programmed tracks.
P
Editing program
Overwriting Programmed Tracks
1. In stop mode, press and hold MODE
to enter program mode.
2. Press MODE to select the pro-
grammed track you want to overwrite.
3. Press Skip backward or Skip for-
ward to select the new track you want
to store.
4. Press MODE to confirm selection.
5. Repeat steps 2 and 3 to overwrite
additional programmed tracks.
Deleting Programmed Tracks
1. In stop mode, press and hold MODE
to enter program mode.
2. Press MODE to select the pro-
grammed track to be deleted.
3. Press and hold DSP for about 3 sec-
onds to delete unwanted track from
your program list, ‘ - - ‘ will show on dis-
play to indicate successful deletion.
4. Repeat steps 2 and 3 to delete addi-
tional tracks from the program list.
5. To cancel editing program, press
STOP once , or unit will return to stop
mode automatically after 30 seconds if
there is no key activation.
File Download
When the unit is connected to the com-
puter, press PLAYto activate, then “USB
Connected” will be displayed on the
screen.
During transfer, “USB Transfer ...” will
flash. When the transfer is complete, the
display will change to "USB Connected".
Do not unplug the USB cable when the
display is flashing.
NOTE:
See Software Instruction Manual for
instructions to install USB driver , music
management software and to transfer
tracks to player and/or memory card.
P
RD1021/1071 IB-EN 5/19/03 2:55 PM Page 14