Filter
Top Products
Other Connections
11
8. Rotate
BRIGHT
and
VOLUME
,
located
below the LCD to
adjust the LCD’s brightness and the DVD player’s
volume.
9. To stop playing a disc, press
STOP
'
.
• When you stop playing a disc, the DVD player
remembers where you stopped.
• When you press
PLAY
J
to start playing the disc
again, the player picks up where you left off unless
you removed the disc or unplugged the DVD player.
10. To turn off the DVD player, press
POWER
on the DVD
player. The DVD player’s POWER indicator turns off.
To turn off the display, slide
OFF/ON
to
OFF
. The LCD’s
POWER indicator turns off.
16*'4"%100'%6+105
You can connect your DVD player to a TV, a TV and Audio/
Video receiver, a camcorder, a game system console, or a
digital camera.
%100'%6+0)"61"#"68
Position Cables Properly to Avoid Audio
Interference.
• Insert each cable firmly into the
designated jack.
• If you place components above the
TV, route all cables down the side of
the back of the TV instead of straight
down the middle of the back of the TV.
• If your antenna uses 300-ohm twin
lead cables, do not coil the cables.
Also, keep the twin lead cables away
from audio/video cables.
1. Connect the supplied Audio/Video
cable’s yellow plug to the
VIDEO
OUTPUT
jack on the back of the DVD
player and connect the yellow plug’s
other end to the TV’s Video Input jack.
2. Connect the supplied Audio/Video
cable’s red plug to the
AUDIO OUTPUT
R
socket on the rear of the DVD
player. Connect the red plug’s other
end to the TV’s Audio Input Right jack.