Filter
Top Products
EN
5
Optional ID-8 and ID-8T Mounting Procedure (continued)
3- Choose the appropriate rubber sealing gasket and thread
the speaker wire through it. Make sure the tapered side of
the gasket is toward the cover. Push the gasket into its seat,
and thread the nut over the speaker wire and tighten.
4- Trim the wires to the appropriate length. Strip the wires
and secure them to the terminals.
5- With the latch open, align the loudspeaker with the Intel-
liDock and slide the loudspeaker into place. Push the latch
down until in engages with the locking tab.
6- Aim the loudspeaker in the desired direction and tighten
the Allen (hex) retaining screw using the tool provided.
Snug the bolt then tighten exactly 5/8 of a turn (225° rota-
tion) to positively secure the ball- mount. If a torque wrench
and appropriate hex bit are available, tighten the bolt to 16
N-m (12 lbs-ft). If extra theft deterrence is required, install
the provided security screw. Attach a safety cable to the
loudspeaker’s safety cable attachment point.