Filter
Top Products
12
SPEAKER WIRING
Using 14 gauge or larger, run the speaker wires from the amplifier
location through the vehicle to the speakers. Observe the same
precautions for routing these wires that you followed for running
the power and remote turn-on wires. Locate the speaker/remote
turn-on
PowerLock
connector.
Right Speaker negative
Right Speaker positive
Remote turn on
Left Speaker positive
Left Speaker negative
Speaker
Power
Lock
Connector
Speaker/Remote
PowerLock
Although the
PC1400/PC1800
is a mono amplifier, you will notice
that there are two 'speaker negative' and two 'speaker positive'
terminals as well as the 'remote turn-on' terminal. The two pairs of
speaker terminals are parallel with each other, so you can use
one each of the positive and negative, or you can use both sets
for two speakers. Cut off excess and, using wire strippers, strip 1/
4 inch of insulation. Loosen the appropriate screws on the
underside of the connector, and insert the speaker leads into the
end. Check to be sure you've maintained proper polarity before
securing each wire, then plug the
PowerLock
connector into the
amplifier with the screws facing down.
BACK TO CONTENTS