Filter
Top Products
DVC-2000
13
• Press VCR button to change into VCR mode
1 Press the SETUP button on the remote control.
2. Press the button to select the “Option”, and press ENTER
button.
3. Press the button to select the “Auto Power Off”.
4. Press ENTER button, until the appropriate system is
selected.(“Yes” or “No”)
5. Press SETUP button to quit.
• Press VCR button to change into VCR mode
1. Press the SETUP button on the remote control.
2. Press the button to select the “Option”, and press
ENTER button.
3. Press the button to select the “Output Channel”.
4. Press ENTER button, until the appropriate system is
selected. ( “CH3” or “CH4” )
5. Press SETUP button to quit.
• Press VCR button to change into VCR mode
1 Press the SETUP button on the remote control.
2. Press the button to highlight and select the “Option”, and
press ENTER button.
3. Press ENTER button until the appropriate system is
selected.(“On” or “Off”)
4. Please press SETUP button to quit.
VCR Setting
Auto Power Off
Setting The OSD Display
RF Out
Tape Handling
1. Do not use any tape below. Damage of video head or
cut/coiling of tape may cause failure.
-Tape with mold
-Tape stained with juice or attachments
-Tape having breakage connection
-Disassembled tape
2. Moisture condensation may occur in tape. Moisture
condensation damages the tape. Please use the tape after the
moisture condensation is disappeared.
3. After use, store tape vertically in a case to prevent loose.
4. Do not store in the following places.
-High temperature and humidity
-Subject generation of mold
-Subject to direct sunlight
-Much dirt or dust
-Near strong magnetic materials such as speaker