Filter
Top Products
35
Check if the disc is inserted with the
graphics side (label) facing up.
Wait for the condensation moisture on the
lens to clear.
Replace or clean the disc.
Use a nalized CD-RW or CD-R.
•
•
•
•
Ensure that the turbo mode of your
wireless router is switched off, if your
router has this function.
The wireless rmware update failed, what do
I do?
1 Ensure that the PC is connected to the
Internet.
2 Use an Ethernet cable (sold separately) to
connect the WAC7500 to the PC.
3 On the PC, launch the WADM on the PC
to update the rmware.
I have problems installing WADM or launching
WADM after installation, what do I do?
Ensure that the operating system of the PC
meets the requirements.
Ensure that the PC is virus-free.
Some les on the USB device are not
displayed, what do I do?
Check if the number of folders exceeds 99
or the number of titles exceeds 999.
Only completely recorded MP3/WMA les
can be found and played. Check if the le
has been recorded completely.
DRM-protected WMA les cannot be
played.
The remote control does not function
properly, what do I do?
Reduce the distance between the remote
control and the WAC7500.
Insert the batteries with correct polarity
(+/- as indicated inside the battery
compartment).
Replace the batteries.
Point the remote control directly at the
infrared sensor.
The screen of the WAC7500 is stuck in a
menu or shows no response for a long period
of time (2-5 minutes), what do I do?
Press
.
If the problem persists, restart the power
(disconnect and reconnect the power
plug) to reset the WAC7500.
‘No Disc’ / ‘Cannot read CD’ is displayed,
what do I do?
Insert a suitable disc.
•
•
•
•
•
•
•
•
•
•
•
•
•
Troubleshooting
English
EN