Philips SA4DOT04 MP3 Player User Manual


 
13EN
7 Technical data
Power
Power supply: 110 mAh Li-ion polymer
internal rechargeable battery
Play time¹
Audio (.mp3): up to 6 hours
Fast charging: 6-minute charging for
60-minute play
Software
Philips Device Manager: To update the
rmware and recover the player
Connectivity
Headphone 3.5 mm
USB 2.0 High speed
Sound
Channel separation: 45 dB
Frequency Response: 20-18,000 Hz
Output power: 2 x 2.4 mW
Signal to noise ratio: > 84 dB
Audio playback
Supported formats:
MP3
Bitrate: 8-320 kbps and VBR
Sampling rates: 8, 11.025, 16, 22.050,
32, 44.1, 48 kHz
WMA (unprotected)
Bitrate: 5-320 kbps
Sampling rates: 8, 11.025, 16, 22.050,
32, 44.1, 48 kHz
WAV
Storage media
Built-in memory capacity²:
SA4DOT02 2 GB NAND Flash
SA4DOT04 4 GB NAND Flash
SA4DOT08 8 GB NAND Flash
Media transfer³
Windows Explorer (drag and drop)
Note
Specications are subject to change without notice.
¹ Rechargeable batteries have a limited number of
charge cycles. Battery life and number of charge cycles
vary by use and settings.
² 1 GB = 1 billion bytes; available storage capacity is
less. Full memory capacity may not be available as some
memory is reserved for the player. Storage capacity
is based on 4 minutes per song and 128-kbps MP3
encoding.
³ Transfer speed depends on operating system and
software conguration.
PC requirements
Windows® XP (SP3 or above) / Vista / 7
Pentium III 800 MHz processor or higher
512 MB RAM
500 MB hard disk space
Internet connection
Windows® Internet Explorer 6.0 or later
CD-ROM drive
USB port