Filter
Top Products
POWER SUPPLY/LINE OUT
9
Only use the AY 3160 power adapter
(4.5 V/400mA direct current, positive pole to the
center pin). Any other product may damage the set.
1 Make sure the local voltage corresponds to the
adapter’s voltage.
2 Connect the power adapter to the 4.5V DC jack
of the player and to the wall outlet.
Note: Always disconnect the adapter when you are not using it.
You can connect the CD player to an additional audio
equipment, E.g. amplifier, radio cassette recorder, etc.,
with a LINE IN jack.
1 Turn down the volume on the additional audio
equipment.
2 Connect an audio signal cable (not supplied,) to the
LINE OUT / p jack of the CD player and the CD IN, AUX IN or LINE IN jack of the
additional audio equipment.
3 To adjust the sound and volume, use the controls on the connected audio
equipment and on the CD player.
Line out
4
.5
V
D
C
Power adapter (supplied or optionally available)
English
L
IN
E
O
U
T
/
The player complies with the FCC-Rules, Part 15 and with 21 CFR 1040.10.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that
may cause undesired operation.
EXP201/17 eng 27/7/01 15:23 Page 9