Filter
Top Products
13
English
Installation
Setting the clock
The time is displayed using the 12-hour clock.
1 Check the set is switched to standby mode.
(see Basic Functions, Switch on/to
standby)
➜--:-- flashes by default if the clock is not set..
2 On the set, press CLK/DISP (or
CLOCKSET on the remote control)
➜ The hour digits start flashing (AM 12: 00 by
default).
3 Hold down or press TUNING/CLOCK + or
- repeatedly to set the hour. Release
TUNING/CLOCK + or - when you have
reached the correct setting.
4 Press CLK/DISP to confirm the setting.
➜ The minute digits start flashing.
5 Repeat step 3 to set the minute.
6 Press CLK/DISP to confirm the setting.
➜ The clock shows the set time.
Helpful hints:
–You may lose your clock setting when the power
cord is disconnected or power failure occurs.
Using the TV screen
The set is equipped with a 7” TFT LCD
monitor. You can watch TV on it. If you insert a
disc, it will serve as an additional display for
messages (e.g. PLAY, STOP), and information
stored on the disc.
1 Press PUSH at the bottom of the set to release
TV panel.
2 Pull the down the panel (maximum 115
0
).
3Turn around the panel to find the screen.
4Adjust the screen to a suitable angle (maximum
270
0
).
PUSH
115
270 maximum
maximum
1,2
3
4
CLOCKSET PICTURE
VOL
DSC