Filter
Top Products
28
Record
Table of contents
Note
• Start a new recording: To stop the current recording and start
a new one, press b.
• Start playback: While recording, presse. The current
recording session is stopped and the last three seconds of the
recording are played back.
• Add index marks: During a recording, press the INDEX/a to
add an index mark (see also chapter 5.1.2 Add index marks, page
29).
• To prevent files getting to big during a long recording, a meeting
that lasts several hours for example, you can automatically split
recordings (see also chapter 9.1.12 Set auto divide, page 46).
• Each folder can store up to 99 files. The size of the memory
depends on the location folder and the quality of a recording (see
also chapter 9.1.3 Set recording quality, page 41).
If the recording time or the number of files exceeds the available
capacity, recording stops and a message is displayed. You can not
make any more recordings. Delete the recordings which you no
longer require, or connect the device to a computer and transfer
the files to your computer.
Tip
• DVT3000 – DVT7000: Manual microphone sensitivity
Press + / – during recording to adjust the microphone sensitivity.
• If you are to start a long recording session, replace or recharge
the batteries before you begin. You can also connect the device
to a computer using the USB cable. The device is supplied with
power over the USB cable when connected to the computer and
the batteries are not drained.
• DVT5500, DVT7000: Use the remote to control the recording
session. Press the { REC/PAUSE key to start or pause
recording. Press the j STOP key to stop recording.
• DVT5000 – DVT7000: Press the F1/F2 keys to call up settings
menu for microphone sensitivity and recording quality.
5.1.1 Record using an external microphone
If you connect an external microphone to the device, the recording
source will switch automatically and the device's microphone will be
turned o. When you connect a mono microphone or an amplified
recording source (e.g. a stereo system) to the microphone port, you
should set the external source (see also chapter 9.1.14 Selecting an
external sound source, page 47).