Philips DTB297 MP3 Docking Station User Manual


  Open as PDF
of 22
 
12 EN
5 Listen to radio
Note
• For optimal reception, fully extend the antenna and
adjust its position, or connect an outdoor antenna.
• This product does not support MW (medium wave)
radio reception.
• You can program a maximum of 20 DAB radio stations
and 20 FM radio stations.
• Check with local retailer or go to www.WorldDAB.org
fortheapplicableDABradiofrequenciesinyourarea.
• Refer to "Product information" > "RDS program types"
for more information about RDS radio stations.
Store DAB radio stations
automatically
If no DAB radio station is stored, this product
can search and store DAB radio stations
automatically.
1 Press SOURCE repeatedly to select the
DAB source.
» [FULL SCAN] (full scan) scrolls on the
display panel.
2 Press OK/ to start auto installation.
» This product automatically stores DAB
radiostationswithsufcientsignal
strength.
» After all available DAB radio stations
arestored,therststoredDABradio
station is broadcast automatically.
Basic operations
Follow the instructions below for more
functions.
Tune to the next FM radio station with
sufcient signal strength at the lower/higher
frequency:
Press and hold TUNING +/- / to start
auto search.
Tune to the FM radio station at a specic
frequency:
Press TUNING +/- / repeatedly until the
frequencydigitalsaredisplayed.
Program FM radio stations automatically:
Press SCAN/PROG/ to start auto
programming.
Program DAB radio stations automatically:
Press SCAN/PROG/ to start auto
scanning and programming.
Program radio stations manually:
1) Tune to a radio station.
2) Press and hold SCAN/PROG/ to
activate programming.
3) Press PRESET +/- / to assign a
sequencenumbertotheradiostation.
4) Press OK/ toconrm.
5) Repeat steps 1-4 to program more radio
stations.
Tune to a preset radio station:
Press PRESET +/- / repeatedly.
Switch the audio mode between [STEREO]
(stereo) and [MONO] (monophonic) for FM
radio:
Press OK/ repeatedly.
Display available information about the
current radio station:
Press MENU/INFO/SET TIME/ repeatedly.
Use the menu
When you listen to radio, you can access the
menu for control options.
1 Press and hold MENU/INFO/SET TIME/
.
» FM mode: [SCAN] (scan) is displayed.
» DAB mode: [FULL SCAN] (full scan)
is displayed.
2 Press TUNING +/- / to select a
menu option, and then press OK/ to
conrmtheoptionorenterthelower-level
menu.
 previous next