Philips DCM250/37 MP3 Docking Station User Manual


 
EN 27
English
Wait until the moisture condensation at
the lens has cleared.
Replace or clean the disc.
UseanalizedCDorcorrectformatdisc.
Cannot display some les in USB device
ThenumberoffoldersorlesintheUSB
device has exceeded a certain limit. This
phenomenon is not a malfunction.
Theformatsoftheselesarenot
supported.
USB device not supported
The USB device is incompatible with the
DCM250. Try another one.
Poor radio reception
Increase the distance between the
DCM250 and your TV or VCR.
Fully extend the FM antenna.
Timer does not work
Set the clock correctly.
Switch on the timer.
Clock/timer setting erased
Power has been interrupted or the power
cord has been disconnected.
Reset the clock/timer.
12 Troubleshooting
Warning
Never remove the casing of this apparatus.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
apparatus, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips web site (www.
philips.com/welcome). When you contact
Philips, ensure that the apparatus is nearby
and the model number and serial number are
available.
No power
Ensure that the AC power plug of the
unit is connected properly.
Ensure that there is power at the AC
outlet.
To save power, the system switches
off automatically 15 minutes after track
play reaches the end and no control is
operated.
No sound or poor sound
Adjust the volume.
Disconnect the headphones.
No response from the DCM250
Disconnect and reconnect the AC power
plug, then turn on the system again.
Remote control does not work
Beforepressinganyfunctionbutton,rst
select the correct source with the remote
control instead of the main unit.
Reduce the distance between the remote
control and the DCM250.
Insert the battery with its polarities (+/–
signs) aligned as indicated.
Replace the battery.
Aim the remote control directly at the
sensor on the front of the DCM250.
No disc detected
Insert a disc.
Check if the disc is inserted upside down.