Philips DCM250/37 MP3 Docking Station User Manual


  Open as PDF
of 28
 
14 EN
Note
• Before pressing any function button on the remote
control,rstselectthecorrectsourcewiththeremote
control instead of the main unit.
• If you are not going to use the remote control for a
long time, remove the battery.
Auto install radio stations
When you connect power and no radio
stations are stored, the DCM250 automatically
begins to store radio stations.
1 Connect the DCM250 to the power
supply.
» [AUTO INSTALL - PRESS PLAY] (auto
install - press the PLAY button) is
displayed.
2 Press on the main unit to start
installation.
» The DCM250 automatically stores
radiostationswithsufcientsignal
strength.
» When all the available radio stations
arestored,therstpresetradiostation
is broadcast automatically.
Set clock
1
In standby mode, press PROG to activate
the clock setting mode.
» The 12 hour or 24 hour format is
displayed.
2 Press / to select 12 hour or 24 hour
format.
3 Press PROG.
» The hour digits are displayed and begin
to blink.
4 Press / to set the hour.
5 Press PROG.
» The minute digits are displayed and
begin to blink.
6 Press / to set the minute.
7 Press PROGtoconrm.
Turn on
1
Press .
» The DCM250 switches to the last
selected source.
Switch to standby
1 Press to switch the DCM250 to
standby mode.
» The backlight on the display panel is
reduced.
» The clock (if set) appears on the
display panel.
To switch the DCM250 to Eco Power
Standby mode:
1 In standby mode, press and hold for
more than 2 seconds.
» The backlight on the display panel
turns off.
 previous next