Filter
Top Products
16
English
Basic Functions
Important!
Before you operate the system, complete
the preparation procedures.
Switching the system on
● Press STANDBY-ON/ECO POWER B (or
B on the remote).
➜ The system will switch to the last selected
source.
● Press SOURCE on the top of the system or
CD, USB, iPod, TUNER or AUX on the
remote control.
➜ The system will switch to the selected source.
Switching the system to standby
mode
● Press STANDBY-ON/ECO POWER B (or
B on the remote).
➜ The backlight for clock display is dim in
standby.
➜ The volume level (up to a maximum volume
level of 12), interactive sound settings, last
selected mode (ECO Power Standby or normal
standby), source and tuner presets will be
retained in the player's memory.
Switching the system to Eco
Power Standby mode
● Press and hold STANDBY-ON/ECO
POWER B (or B on the remote) for more
than 2 seconds.
➜ The backlight will go blank.
Power Saving Automatic Standby
As a power-saving feature, the system
automatically switches to Eco Power/ Standby 15
minutes after a CD/MP3/WMA/USB playback
has reached the end and no control is operated.
Adjusting volume and sound
1 Press VOLUME +/- (or VOL +/- on the
remote control) to decrease or increase the
volume.
➜ Display shows the volume level VOL and a
number from MIN 01, 02, ...31 MAX.
2 Press DSC repeatedly to select the desired
sound effect: ROCK/POP/JAZZ/CLASSIC.
3 Press DBB to switch bass enhancement on or
off.
➜ If the DBB is activated, DBB ON is shown.
➜ If the DBB is deactivated, DBB OFF is shown.
4 Press MUTE on the remote control to
interrupt sound reproduction instantly.
➜ Playback will continue without sound and --
MUTE-- will flash on the display.
● To activate sound reproduction you can:
– press MUTE again;
– adjust the volume controls;
– change source.
To listen through the headphone
● Connect the headphone plug to the n socket
on the rear of the set.
➜ The speakers will be muted.
TIMER
iPod
pg001-029_DCM230_37-Eng 1/9/08, 16:0616