Filter
Top Products
13EN
Charge the iPod/iPhone/iPad
When the product is connected to power,
the docked iPod/iPhone/iPad starts charging
automatically.
Tip
• For certain iPod models, it may take up to a minute
before the charging indication appears.
Listen to the iPod/iPhone/
iPad
1 Press DOCK to select the iPod/iPhone/
iPad source.
2 Select and play a track on your iPod/
iPhone/iPad.
• To pause or resume the play, press .
• To skip to the previous or next track,
press
/ .
• To search during play, press and hold
/ , and then release it to resume
normal play.
• To access the playlist of iPod/iPhone,
press Menu/
.
• To access the playlist of iPad/iPad 2,
operate on the iPad/iPad 2 screen.
• To scroll through the playlist, press
/ .
• To conrm an option, press OK on the
remote control.
Remove the iPod/iPhone/iPad
1 Pull the iPod/iPhone/iPad out of the dock.
2 Flip down the lid to hide the dock.
7 Listen to radio
Note
• For optional reception, fully extend the antenna and
adjust its position, or connect an outdoor antenna.
• This product does not support MW (medium wave)
radio reception.
• You can program a maximum of 30 DAB radio stations
and 30 FM radio stations.
• Check with local retailer or go to www.WorldDAB.org
for the applicable DAB radio frequencies in your area.
• Refer to "Product information" > "RDS program types"
for more information about RDS radio stations.
Store DAB radio stations
automatically
If no DAB radio station is stored, this product
can search and store DAB radio stations
automatically.
1 Press DAB/FM repeatedly to switch to the
DAB mode.
» [FULL SCAN] is displayed.
2 Press or OK to start the auto
installation.
» This product automatically stores radio
stations with sufcient signal strength.
» After all available radio stations are
stored, the rst stored radio station is
broadcast automatically.
Basic operations
Follow the instructions below for more
functions.