Philips DC200/79 MP3 Docking Station User Manual


 
5 Press PROG/SET TIME
to confirm.
6
In clock mode, press
ALBUM/PRESET -/+
1 /2 to set your time zone.
7
To zoom in/out the clock display, press
MODE
in clock mode.
TUNER
1
Press
SOURCE
repeatedly to switch on the radio (FM only).
Display shows the radio frequency of the last selected waveband. Your pre-
set station is also shown if you are listening to a preset.
(
See 2
)
2
Adjust the sound using VOLUME 3 /4
.
3 To select preset stations, press ALBUM/PRESET -/+
1 /2
once or repeatedly.
TUNING TO RADIO STATIONS
1 Press and hold
¡1 / 2™
until the frequency in the display starts changing.
After the system tunes to a station of sufficient reception, display shows its
frequency.
•To tune to a weak station, press
¡1 / 2™
briefly and repeatedly until an
optimal reception is found.
To improve reception (FM):
Extend and position the pigtail fully to obtain optimum reception.
STORING AND USING PRESET STATIONS
You can store up to 20 FM radio stations in the memory.
1 Tune to your desired station (see TUNING TO RADIO STATIONS).
2
Press
PROG to activate the programming, and then press ALBUM/PRESET -/+
1
/ 2
to select a desired preset number
.
3
Press
PROG again to confirm.
4
Press
ALBUM/PRESET -/+
1 / 2
to listen to a preset station.
AUTOSTORE: Automatic programming
1
Press and hold
PROG for more than two seconds.
Available radio stations will be automatically stored.
DC200_79_CCR 2008.2.21 17:01 Page 7