Filter
Top Products
Helpful Hints :
– It is normal for the batteries to become warm during recharging.
– If the batteries become too warm, recharging will be interrupted for approximately 30
minutes .
– To ensure proper recharging on board, take care that contacts are clean.
– Use only the ECO-PLUS NiMH battery AY 3362.
AC ADAPTER/CHARGER (SUPPLIED)
Please use only the adapter/charger supplied with your product. Any other
adapter/charger may damage the radio.
You can use the supplied adapter/charger to either:
• operate the radio on AC/DC power
(6V direct current, positive pole to the
current pin)
• charge the supplied rechargeable batteries on board the
radio.
1
Make sure the local voltage corresponds to the adapter's voltage.
2
Connect the adapter to the 6V DC socket of the radio and to the wall socket.
3
If you have inserted rechargeable batteries for recharging, the RECHARGE indicator
lights up during charging. When charging is full, the RECHARGE indicator goes out.
Helpful Hints :
–
Always disconnect the adapter/charger when you are not using it.
–
When charging batteries, do not operate the radio as this will
interrupt charging time and the performance of your rechargeable
batteries.
The serial and production numbers are located inside the battery compartment.
11
Power Supply
English
CAUTION
Use of controls or adjustments or performance of procedures other than
herein may result in hazardous radiation exposure or other unsafe operation.
DA1000/00-ENG 3/15/04 8:59 AM Page 11