Philips AZT9240 Portable CD Player User Manual


 
POWER SUPPLY
9
Recharging works only on players with supplied rechargeable
ECO-PLUS NiMH batteries AY 3362.
Recharging the ECO-PLUS NiMH batteries on board
1 Make sure you insert the rechargeable ECO-PLUS NiMH
batteries AY 3362.
2 Connect the mains adapter to the 4.5V DC socket of
the player and then to the wall socket.
y A is shown and ChArGE is displayed for 5
seconds.
Recharging stops after a maximum of 7 hours, or
when you start playback.
3 When the batteries are fully recharged, and
FULL appear briefly in the display, before the
display switches off.
Notes: – It is normal for the batteries to become warm
during recharging.
– If the batteries become too warm, recharging will be interrupted for
approximately 30 minutes and
Hot
is displayed.
– To ensure proper recharging on board, take care that contacts are clean, and
you are using only the ECO-PLUS NiMH batteries AY 3362.
Rechargeable ECO-PLUS NiMH battery handling
Recharging already charged or half-charged batteries will shorten their lifetime.
Therefore, after using the rechargeable ECO-PLUS NiMH batteries a few times,
discharge them completely before recharging.
To avoid a short circuit, the batteries should not touch any metal objects.
When the batteries quickly become empty after recharging, the contacts are dirty
or the end of their lifetime has been reached.
ECO-PLUS NiMH battery information (for versions supplied with
rechargeable ECO-PLUS NiMH batteries AY 3362 only)
English
AZT9240/01 eng 23/2/01 17:28 Page 9