Filter
Top Products
24
English
ALARM CLOCK
At the set alarm time either the tuner will start playing for 1 hour, the beeper will
come on for 3 minutes or an entire CD will be played.
IMPORTANT!
To ensure your selected beeper, CD or tuner alarm activates at the set time, make
sure you leave the CD player in standby mode.
1 Keep SET· pressed for approximately 2 seconds, then
briefly press SET· twice.
y Either ALbEEP, ALCd or ALtun is displayed.
2 Press 3 or 4 if necessary repeatedly within
5 seconds to select the desired alarm signal until the
display shows either:
ALbEEP: the beeper will be the alarm signal,
ALCd: the CD will be the alarm signal, or
ALtun: the tuner will be the alarm signal.
y At the set time starts flashing and the
selected alarm signal will come on.
• You can deactivate the beeper for 24 hours by
pressing any key on the player.
• If you deactivate the alarm function by switching CD
or tuner play off with 9, CD or tuner play will restart
after 24 hours.
• To switch the alarm function on or off,
keep ESP pressed for approximately 2 seconds.
y is shown if the alarm function is on.
Notes: – If there is no CD inserted or no radio station tuned, the beeper will be taken
as the alarm signal instead.
– If the alarm is activated during CD or tuner playback, playback is interrupted
and you will hear the beeper alarm through the LINE OUT/
p
connection
only, irrespective of your chosen alarm signal.
– In standby mode, the beeper alarm uses the built-in speaker located on the
base of the CD player.
Alarm activation/deactivation
AZT9240/01 eng 23/2/01 17:28 Page 24