Philips AX 1101/10 Portable CD Player User Manual


 
PLAYBACK INFORMATION
If a CD-Recordable (CD-R) or a CD-Rewritable (CD-RW) is not recorded
properly, nF dISC is displayed. In that case, use FINALIZE on your CD-
recorder to complete the recording.
If you want to play a CD-Rewritable (CD-RW), it takes 3–15 seconds for sound
reproduction to start once you have pressed 2;.
Playback will stop if you open the CD lid.
While the CD is being read, 1-:-flashes in the display.
VOLUME AND BASS
Volume adjustment
Adjust the volume by using VOL E.
Bass adjustment
Press BASS to switch the bass enhancement on or off
y is shown if the bass enhancement is
activated.
PROGRAM
MODE
PROGRAMMING TRACK NUMBERS
You can select up to 15 tracks to play in a program.
A single track may be played more than once in
the program.
1 While playback is stopped, select a track with
or §.
2 Press PROGRAM to store the track.
y
PROGRAM lights; the track number
programmed and P, with the total number of
stored tracks, are displayed.
3 Select and store all desired tracks in this way.
4 Press 2; to start playback of your selected tracks.
y
PROGRAM is shown and playback starts.
You can review the program by pressing PROGRAM
for more than 2 seconds.
yThe display shows all stored tracks in sequence.
Notes: – If you press
PROGRAM
and no track is selected,
SELECt
is displayed.
– If you try to store more than 15 tracks,
FULL
is displayed.
Clearing the program
While playback is stopped, press 9 to clear program.
yCLEAr is displayed once,
PROGRAM
disappears, and the program is cleared.
Notes: – The program also will be cleared if you
– interrupt the power supply, or
– open the CD compartment lid, or
– if the unit switches off automatically.
MODE
PROGRAM
p
/
L
I
N
E
O
U
T
p
/
L
I
N
E
O
U
T
p
/
L
I
N
E
O
U
T
p
/
L
I
N
E
O
U
T
PLAYING A CD
This CD player can play all kinds of Audio Discs such as
CD-Recordables and CD-Rewritables. Do not try to play a
CD-ROM, CDi, VCD, DVD or computer CD.
1 Push OPEN 2 to open the CD compartment lid.
2 Insert an audio CD, printed side up, by pressing the
CD center onto the hub.
3 Close the player by pressing the lid down.
4 Press 2; to switch the player on and start
CD playback.
yThe current track number and the elapsed
playing time are displayed.
You can pause playback by pressing 2;.
yThe time where playback was paused will flash.
You can continue playback by pressing 2; again.
5 Press 9 to stop playback.
yThe total number of tracks and the total playing
time of the CD are displayed.
6 Press 9 again to switch off the player.
To remove the CD, hold it by its edge and press the
hub gently while lifting the CD.
Note: If there is no activity, the unit will automatically
switch off after a while to save energy.
0
MODE
SELECTING A TRACK AND SEARCHING
Selecting a track during playback
Briefly press or § once or several times to skip
to the beginning of the current, previous or next track.
yPlayback continues with the selected track, and
its number is displayed.
Selecting a track when playback is stopped
1 Briefly press or § once or several times.
yThe selected track number is displayed.
2 Press 2; to start CD play.
yPlayback starts with the selected track.
Searching for a passage during playback
1 Keep or § pressed to find a particular passage in
a backward or forward direction.
ySearching is started and playback continues at
low volume. After 2 seconds the search speed increases.
2 Release the button when you reach the desired passage.
yNormal playback continues from this position.
Notes: – During SHUFFLE, SHUFFLEREPEAT ALL, REPEAT
or while playing a program, searching is only
possible within the particular track.
PROGRAM
MODE
Both the model number and production number are located on the
bottom of the set.