Philips AJ 3941 Clock Radio User Manual


 
TROUBLESHOOTING
16
English
PROBLEM
POSSIBLE CAUSE
REMEDY
GENERAL
No sound
VOLUME is not adjusted.
Adjust the VOLUME.
Headphones are connected.
Disconnect headphones.
Set does not react to operation of
any of the controls
Electrostatic discharge.
Switch off the set, disconnect the power
plug, reconnect after a few seconds.
CD PLAYER
CD playback does not work
CD is badly scratched or dirty.
Replace or clean the CD, see Maintenance.
Laser lens steamed up.
Wait until lens has acclimatized.
RADIO
Crackling sound during FM broadcast
Weak signal.
Aim and extend the pigtail antenna fully.
Continuous crackling / hiss disturbance
during AM broadcast
Electrical interference from TVs, computers,
fluorescent lamps, etc.
Move the set away from other electrical
equipment.
ALARM
The alarm does not function
Alarm time not set.
Set the alarm time.
Alarm mode not selected.
See chapter on SETTING THE ALARM TIME
Day selection not set/incorrect
See chapter on SETTING THE DAY
Volume too low for RADIO/CD/TRACK
SELECT alarm mode
Adjust the volume
The production plate is located on the
bottom of the set.
Environmental information
All redundant packaging material has been omitted. We have done our utmost to make the
packaging easily separable into three mono materials: cardboard (box), expandable polystyrene
(buffer) and polyethylene (bags, protective foam sheet).
Your set consists of materials which can be recycled if disassembled by a
specialized company. Please observe the local regulations regarding the disposal of
packaging materials, exhausted batteries and old equipment.
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service center.
WARNING: Under no circumstances should you try to repair the set yourself, as this
would invalidate the warranty
XP AJ 3940/3941/17.1 29-03-2001 10:57 Pagina 16