Filter
Top Products
SETTING THE ALARM SWITCHING OFF THE ALARM
10
Gentle wake volume
A sure way of getting up in the mornings, the gentle wake
volume for the alarm begins from zero volume (Lo:00) and
gradually increases to a high of 14 ( ). If, however, you wish
to change the default volume settings for the buzzer melody, radio
or CD alarm:
1. In the standby mode, press ALARM 1 or 2 MODE•OFF once.
2. As soon as Lo:00 appears, press UP7 or DOWN8 once or
more until you reach the desired level (0-32). This sets the
starting volume of your alarm.
3. To set the maximum volume for your alarm, press ALARM 1 or
2 MODE•OFF again to change to the display.
4. As soon as appears, press
UP7 or DOWN8 until you reach the desired volume level (a
number equal or greater than the Lo, low setting).
Notes:
– The gentle wake volume settings do not affect normal CD
playback and radio volume level.
– It is not possible to check the gentle wake volume setting
during the active alarm call as pressing ALARM 1 or 2
MODE•OFF cancels the alarm completely.
– It is not possible to adjust the gentle wake volume during CD
playback mode.
There are three ways of switching off the alarm. Unless you cancel
the alarm completely, the 24-HOUR ALARM RESET will be
automatically selected after 59 minutes, from the time your alarm
time goes off.
24-HOUR ALARM RESET
If you want the alarm to be stopped immediately but also wish to
retain the same alarm setting for the following day:
• Press 24-HOUR ALARM RESET or 9 STOP•OFF.
– You will hear a beep tone to confirm that the 24-HOUR
ALARM RESET has been activated.
CANCELING THE ALARM COMPLETELY
To cancel the set alarm time before it goes off, or during the alarm
call:
• Press 9 STOP•OFF.
• Press ALARM 1 or 2 MODE•OFF once or more until the
selected alarm indicator disappears from the display.
SWITCHING OFF THE ALARM
AJ 3935 /00 page 10
English
gentle wake
B
R
I
G
H
T
N
E
S
S
C
O
N
T
R
O
L
R
E
P
E
A
T
A
L
A
R
M
XP AJ 3936/00-1.1 22-06-2000 12:43 Pagina 10