Philips AJ301DB/79 MP3 Docking Station User Manual


 
TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or
service centre.
WARNING: Under no circumstances should you try to repair the set yourself, as this
will invalidate the guarantee. Do not open the set as there is a risk of
electric shock!
No sound
Volume not adjusted
Adjust the volume
The set is muted.
Press”MUTE” on the remote control to active playback sound.
Display error / no reaction to any controls
Electrical malfunction
Unplug the power cord, then re-plug.
Intermittent crackling sound during FM reception
Weak signal
Extend and position the pigtail aerial
The alarm does not function
Alarm time/ mode not set
See SETTING THE ALARM.
Volume too low for radio
Increase the volume
Dock operation
The menu navigation or photo playback of the docked player cannot be car-
ried out through the buttons on AJ301DB or its remote control.
The buttons on AJ301DB and its remote control can control playback of audio
contents only. To navigate the menu, use the controls on the docked player.
Some buttons on AJ301DB and its remote control have no function.
The buttons ( 2; , ¡1, 2™ and VOLUME ) function only.
SETTING THE ALARM TIME
(See 3)
1 In any mode, press and hold ALM1 or ALM2 for two seconds.
ALM1
/
ALM2
icon and the hour digits flash. And the icon for the current
alarm mode also flashes.
2
Hold down or press ¡1/ 2™repeatedly to set and adjust the hours.
3 Press ALM1 or ALM2
to confirm.
ALM1
/
ALM2
icon and the minutes digits flash. And the icon for the cur-
rent alarm mode also flashes.
4
Hold down or press ¡1/ 2™repeatedly to set and adjust the mintues.
5 Press ALM1 or ALM2
to confirm.
SETTING THE ALARM MODE
1 Press POWERto switch to standby mode.
2
Select your choice of alarm mode: either docked player
,
buzzer, or radio by
using the DOCK
BUZZER TUNER slider.
At the set alarm time, the docked player or radio or buzzer will switch on
automatically.
Helpful hints:
If you have selected TUNER alarm mode, make sure you have properly tuned to a
station before turning off the set.
If you have selected DOCK alarm mode, make sure you have docked the compatible
player, or the buzzer mode will be selected automatically.
To check the alarm time setting forALM1 orALM2, pressALM1 or ALM2.
SWITCHING OFF THE ALARM
There are three ways of switching off the alarm. Unless you cancel the alarm
completely, the 24-hour ALARM RESET will be automatically selected after 59
minutes from the time your alarm first goes off.
24 HOUR ALARM RESET
If you want the alarm mode to be stopped immediately but also wish to retain
the same alarm setting for the following day:
Press
POWER
.