Filter
Top Products
TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or
service centre.
WARNING: Under no circumstances should you try to repair the set yourself, as this
will invalidate the guarantee. Do not open the set as there is a risk of
electric shock!
No sound
– Volume not adjusted
• Adjust the volume
– The set is muted.
•Press”MUTE” on the remote control to active playback sound.
Display error / no reaction to any controls
– Electrical malfunction
•
Unplug the power cord, then re-plug.
Intermittent crackling sound during FM reception
– Weak signal
•
Extend and position the pigtail aerial
The alarm does not function
–
Alarm time/ mode not set
• See SETTING THE ALARM (Dock mode is for Apple iPod and Philips GoGear
SA9100 and SA9200.)
– Volume too low for radio
• Increase the volume
Dock operation
–
The menu navigation or photo playback of the docked player cannot be car-
ried out through the buttons on AJ300D or its remote control.
•The buttons on AJ300D and its remote control can control playback of audio con-
tents only. To navigate the menu, use the controls on the docked player.
–
Some buttons on AJ300D and its remote control have no function.
• The buttons ( 2; , ¡1, 2™ and VOLUME ) function only. For Philips GoGear, fast
forwarding/rewinding is not available.
IFU_AJ300D_eur_eng 2006.11.9 11:04 Page 14