Filter
Top Products
Using AC power
1 Check if the power voltage, as shown on
the type plate located on the rear of
the set,corresponds to your local power
supply.If it does not, consult your dealer or
service center.
2 Connect the supplied switching adapter to
the wall socket and the DC jack on the set.
The set is now ready to use.
3 To switch the set off completely, withdraw the
power cord from the wall socket.
• Install the unit near the AC outlet and where
the power plug can be easily reached.
• Disconnect the power cord from the wall
socket to protect your set during heavy thun-
derstorms.
•AC power cord is used as the disconnect
device. It shall remain readily operable and
should not be obstructed during intended
use.To be completely disconnected the appa-
ratus from supply mains, the power cord of
the apparatus shall be disconnected from the
mains socket outlet completely.
The type plate is located on the
rear of the set.
General information
Antennas
• For FM, extend,incline and turn the telescop-
ic antenna for best reception. Reduce its
length if the signal is too strong.
• For MW, the set uses a built-in antenna.
Direct this antenna for best reception by
turning the whole set.
Connecting earphones
•You can connect headphones to the head-
phone socket.
➜ The loudspeakers will then be switched
off.
DBB sound effect
You can enhance bass by enabling DBB sound
effect.
•To enable or disable DBB sound effect, press
DBB/SET TIME repeatedly.
➜ appears when DBB sound effect is
enabled.
DBB
Power Supply General Information
AE2790_12_A_CCR 2008.2.19 16:26 Page 6