Filter
Top Products
Basic operation
1 Connect the supplied switching adapter to
the wall outlet and the DC jack on the set
or insert batteries as described in Power
Supply.
➜
The clock information is displayed.(See
2
)
• Press
2
to switch on the set.
• Press
2
again to switch to standby mode.
2 To adjust volume, press VOLUME +/–.
Helpful hints:
– When there is no power supply for the set,
time information can still be displayed for a
few minutes.
– After a few minutes, appears and flashes
and then time information is cleared.
Switching on radio
1 Press
2
to switch on the set.
2 Press SOURCE to select FM, MW, SW, or
LW waveband.
➜ Waveband and radio frequency are dis-
played
(see
3
).
Auto tuning
• Press TUNING 1 / 2 and hold it for one
second; the set searches a station automati-
cally.
➜ Sr ch appears.
➜ When a station is received, search stops
and Sr chdisappears.
Helpful hints:
–You can press any button to exit automatic
search.
Manual tuning
By using this feature, it is possible to manually
tune to a specific channel frequency.In addi-
tion to antenna orienting for better radio
reception, the optimum reception can also be
obtained by using this feature.
• In FM, MW, SW, and LW mode, press TUN-
ING
1 / 2 to tune to stations.
Helpful hints:
– Press 1 / 2 once to increase or decrease
the frequency by 5KHz. But the frequency
change is not displayed.
– Press 1 / 2 twice to increase or decrease the
frequency by 10KHz. The frequency change
displayed is +/- 0.01MHz.
Basic Operation Radio
A 2008.3.25 11:47 Page 7