Panasonic SL-CT495J MP3 Player User Manual


 
Button Display/reference
Operation
To pause play
To stop play
To turn off the
unit
Skip forward/
backward
(skip function)
Rapid forward/
backward
(search function)
Off mode
Stop mode
2
14
5
HOLD
3
H
O
L
D
Ë
O
P
E
N
VOL
M
E
M
O
R
Y
R
E
C
A
L
L
EQ
MODE
OPEN
S-XBS
VOL
C
VOL
S-XBS
C
L
R
VOL
For your reference:
) indication
This indication appears for about 30 seconds if [1/;] is
pressed when no disc is loaded in the unit or if the disc
is not properly secured.
* indication
This indication appears for about 10 minutes when the
cover is opened. (However, the indication does not ap-
pear when the unit is powered off.)
Removing discs
1 Press [] to stop play and disc rotation.
2
Slide [OPEN 1] to open the lid.
3 Once the disc has stopped, lift the disc
out with your finger.
Do not stop the disc by hand or try to remove it before it
stops rotating. This can damage CDs.
Note!
Never insert foreign objects into the unit.
Auto-off function
If you leave the unit in stop mode for about 10 minites
(30 seconds if disc is not loaded), it turns off to save the
batteries.
3
Sequential Play
Basic Play
Elapsed playing time of each track
Track number in play
Close the lid
Plug type:
3.5 mm (1/8 in.) stereo
Decrease Increase
During program play (page 4), these buttons are
used to skip forward or backward through the
programmed sequence of tracks.
You cannot skip to tracks that have been played
in random or random repeat play (page 4).
During program play, 1-track repeat play, random
play and random repeat play (page 4), search op-
eration is limited to the current track only.
Press during play.
Press during play.
Press during stop mode.
Press during play.
(Press [:] twice to skip to the
beginning of the previous tracks.)
Press again to restart play.
Press and hold during play.
Backward Forward
C
C
C
Total number of tracks
Total playing time
Resume function notes
Opening the lid while in the stop mode or replacing the disc while in the off mode cancels the function. (It may re-
main active if you replace a disc in the off mode.)
Play may resume from the beginning of the next track if you stopped play near the end of a track.
The resume function works automatically and cannot be turned off.
No indicator is shown.
Resume function
Play starts from the beginning of
the current track the next time you
press [1/;].
Note on CD-R and CD-RW
This unit can play CD-DA format audio CD-R and
CD-RW that have been finalized
§
upon completion
of recording. It may not be able to play some CD-R
or CD-RW due to the condition of the recording.
§
Finalizing is a process that enables CD-R/CD-RW
players to play audio CD-R and CD-RW.
Follow steps 15.
In step 2: Connect the clip headphones/ stereo earphones and wired remote control to the headphone jack [Ë] .
(Plug in firmly.)
In step 5: The volume range is 0-25. Press and hold to change the volume successively. The volume changes when
pressed while the level is displayed. If any other display is shown, it changes to show the current level.
(The volume returns to 10 when you disconnect the power source.)
Play stops automatically when all the tracks have been played.
If the unit has been connected to the car audio system, set this units volume to 10, then adjust the volume level on
the system.
Label must face
upward. Press
near the center
so the disc clicks
firmly into place.