Filter
Top Products
52
RQT6951
Other speaker setup options
[Note]
The wall or pillar on which the speakers are to be attached should be capable of supporting 10 k
g
(22 Ib.) per screw.
1 Remove the stand. (SC-HT810V only)
BEFORE REMOVING THE STAND
≥Take the speaker cable out of the stand’s hole if it is
threaded through.
≥Lay the speaker on a soft cloth.
Unscrew the screw with a Phillips-head screwdriver.
2 Screw a screw (not included) into the
wall.
3 Fit the speaker securely onto the
screw with the hole or holes.
Preparation
≥Remove the stand (SC-HT810V only ➡ step 1 above).
≥Ensure the stands meet these conditions before purchasing them.
–Observe the diameter and length of the screws and the distance
between screws as shown in the diagram.
–The stands must be able to support over 10 k
g
(22 lb.).
–The stands must be stable even if the speakers are in a high
position.
Attaching to a wall
Stand
30–35 mm (1
3
/
16
q–1
3
/
8
q)
Wall
‰7.5–9.4 mm (
19
/
64
q–
3
/
8
q)
8–11 mm (
3
/
8
q–
7
/
16
q)
Vertical Horizontal
100 mm
(3
15
/
16
q)
Fitting speaker stands (optional)
5 mm (
13
/
64
q), pitch 0.8 mm (
1
/
32
q)
60 mm (2
23
/
64
q)
Plate thickness plus 7 to 10 mm
(plus
9
/
32
q to
25
/
64
q)
Speaker stand
(not included)
Attach the stands
with these holes.