Filter
Top Products
12
English
13
CQ-VX100U
Anti-Theft System
Caution
¡ Be sure to follow the procedure mentioned above to mount the face plate appropriately. Improper mounting such
as forcible mounting without engaging the concave parts with the convex parts may cause trouble.
¡ Use caution not to damage the detection switch while mounting the face plate. Failure to observe this may cause
trouble.
¡ Use caution not to apply excessive force to the removed face plate when the plate is carried or stored. Failure to
observe this may cause trouble.
¡ This face plate is not waterproof. Do not expose it to water or excessive moisture.
¡ Do not remove the face plate while driving your car.
¡ Do not place the face plate on the dashboard or nearby areas where the temperature rises high.
Face Plate Removal Alarm
This alarm sounds to warn you not to forget to remove
the face plate before leaving your car.
This function is activated when is set to
). (
a
page 33)
On
Security Alarm
TILT
CQ-VX100U
DIMMER
DIM
TUNE/TRACK
MUTE
SETUP
SOURCE
POWER
VOL
PUSH
SEL
AV1 IN
OPEN
This unit is equipped with a removable face plate.
Removing this face plate makes the unit totally inopera-
ble.
Install the Face Plate
q
Engage the right and left concave parts (A) on the
lower rear side of the face plate with the convex parts
(B) of the main unit.
w Raise and press the face plate toward the main unit
until a click is heard while engaging (A) with (B).
Removable face plate
Remove the Face Plate
q
Switch off the power of the unit.
w Hold the top and bottom of the center part of the face
plate and pull it down toward you.
e Pull the face plate toward you.
r Place the face plate into the case and take it with you
when you leave the car.
w
e
(
B
)
(
B
)
(
A
)
(
A
)
q
w
Detection switch