Filter
Top Products
CQ-C3305W
10
CQ-C3305W
11
English
General, Sound Control
SQ Selection Based on Genre
SQ (Sound Quality)
The equalizer curve is selectable from among 4 types
(FLAT, ROCK, POP and VOCAL) depending on your
listening category.
SQ changeover
The SQ category is changed every time [SQ] (Sound
Quality) is pressed.
(FLAT) fl at frequency response:
does not emphasize any part.
(Default)
(ROCK) speedy and heavy sound:
exaggerates bass and treble.
(POP) wide-ranged and deep sound:
slightly emphasizes bass and treble.
(VOCAL) clear sound:
emphasizes middle tone and slightly
emphasizes treble.
Press [DISP] to return to the regular mode.
Notes:
• Setting of SQ, bass/treble and volume are infl uenced
one another. If such an infl uence mentioned above
causes distortion to the audio signal, readjust bass/
treble or volume. (
page 20)
• Please refer to page 20 for the adjustment to each
speaker.
· Bass adjustment
· Treble adjustment
· Balance adjustment
· Fader adjustment
Source Selection
(SOURCE)
The source changes as follows every time [SOURCE]
is pressed.
AUX1 (AUX1 in) (3.5 mm stereo)
From line output of external sound/audio device (ex.
Silicon-audio player, HDD player, etc.)
General
Volume off (down)
Press [MUTE].
Cancel
Press [MUTE] again.
Note: You can select mute or attenuation. ( page 21)
Up
Down
Setting Range: 0 to 40
Default: 18
Note: The volume level can be set independently for
each source. (For radio, one volume setting for AM, one
volume setting for all FMs)
Volume
Adjustment
(VOLUME)
Temporary Volume Off
(Down)
MUTE (ATT: Attenuation)
Radio
FM1, FM2, FM3, AM ( page 12)
Player
When loading CD ( page 14)
When loading MP3/WMA disc ( page 16)
AUX1
Device connected to the AUX1 terminal of this unit
Sound Control
Caution
• Set the volume level to low enough before the
AUX connection is completed.
Failure to observe this, the loud noise may come
out and damage your speakers and your hearing.
When an optional device is connected:
Shift to connected device
When connecting CD changer
When connecting iPod
OR
When an expansion module is connected:
The devices connected to the ports 1 to 4 are activated
in sequence after shifting to AUX2 (device connected
to the AUX terminal of the expansion module).
System-up Connector
Note:
For information about connectable devices, refer
to the System Upgrade Guidebook or the instruction
manual for each device.