- 18 -
Radio Function
Radio Function Operation
Press the AM/FM button on the remote control or SOURCE button on the front panel
to enter the AM/FM radio mode. Press and hold the SEEK+/SEEK- button for about 1.5
seconds to start searching forward/backward from the current frequency. Press the
SEEK+/SEEK- button again to stop searching. The radio frequency will be displayed on
the display panel. The frequency range of FM is from 87.5MHz to 108MHz; frequency
range of AM is from 531kHz to 1602kHz.
Fine Tuning
Press the SEEK+/SEEK- button to fine tune the frequency forward/backward under
radio mode.
Semi-memorising radio stations
If you like a radio station and want to store it for later listening, press the SET button
to memorise it. "SAVE X X" will be displayed on the display panel, "X X" represents
the default station number.
There are two methods to organise the saved stations:
Use the / (CH+/CH-) buttons to adjust the channel number for your
preference, and then press the SET button again the station will be memorised
with the code station number.
Press the SET button again, the station will be automatically memorised with the
default station number in sequence.
You can store radio stations from 0 to 19, total 20FM or 20AM radio stations. If no
buttons are pressed within 3 seconds of pressing the SET button the first time, the
frequency will appear on the display panel again, and the station will not be stored.
Accessing memorised radio stations
First use the number buttons on the remote control for input, then press the OK
button for confirmation to go to the selected radio station directly. Or without
pressing any button and wait a moment, it also goes to the selected radio station
Press the / (CH+/CH-) buttons to select the radio stations forward and
backward.
When selecting the stations, the "CH XX" will appear on the display panel, where the
"XX" is the channel number of the stored radio station. After a few seconds, the "CH XX"
disappears and the radio frequency will be displayed once again.