Filter
Top Products
Part Number 10400007-101 04/2007 ©2007 Overland Storage, Inc. W Page 3 of 4
ARCvault Overview
Tape cartridges are loaded using the tape magazines
provided. The ARCvault 48 has four magazines, two on
each side. As a safety feature, the magazine doors must be
shut before the internal robotics can function.
There are two ways to interface with an ARCvault unit—
the Operator Control Panel (OCP) touch screen on the
front panel (Figure 5) or Remote Management Utility
(RMU) accessed via a web browser using the default IP
address of 10.0.0.1.
Figure 5. ARCvault Front Panel
All cabling and power connections, along with the unit’s
power switch, are located on the rear panel (Figure 6). On
a SCSI configuration, the top two SCSI ports connect to
Drive 1 and the bottom two ports connect to Drive 2.
Access to the tape drive bay is available through the tape
drive cover assemblies. Connections are available for
Ethernet and serial cabling. All unit cooling exhaust is
handled through the rear panel.
Figure 6. ARCvault Rear Panel (SCSI Configuration)
Attaching Cables
You are ready to connect the unit to your host system. For
additional information, see the ARCvault 48 User Guide.
SCSI Drives - Single Host
The default SCSI configuration is two half-height drives.
1. Connect the LVD SCSI cable to the top SCSI port and
the other end to your system.
2. Attach the SCSI jumper cable between the second
and third ports (Drives 1 and 2).
3. Attach the SCSI terminator to the fourth SCSI port.
A
R
C
-
0
0
3
7
Retaining Thumbscrews Operator Control Panel
Tape Cartridge Magazines
Open Door
Door Handle
Ventilation Slots
A
R
C
-
0
0
0
9
SCSI Ports
AC Receptacle
Ethernet Port Serial Port
Power Switch
Thumbscrews
System Exhaust FanTape Drive Cover
Lower Drive Bay Cover