Filter
Top Products
RADIO SECTION
RADIO RECEPTION
NOTE: In Radio operation mode, press Display/AL.Set button to display the clock time.
1.
Press Power/AL. off button to turn on the unit.
2.
Press RADIO button to select radio.
3. Select AM/FM band by pressing the STOP/BAND button. AM and FM are alternately selected each time when the
STOP/BAND button is pressed.
4. How to use the buttons for radio
a. Manual Tuning
----Higher frequency can be selected by pressing the “SKIP >>|” button
----Lower frequency can be selected by pressing the “SKIP |<<” button
b. Automatic Tuning
-----Press and hold the “SKIP >>|” or “SKIP |<<” button until the display frequency starts run.
-----When a station of sufficient strength has been found. Tuning will stop or you can stop the automatic tuning by pressing
“SKIP >>|” or “SKIP |<<” button again.
-----Repeat until you have found the desired station.
5. Adjust the volume to the desired level. by pressing VOL. UP or VOL. DOWN button.
6. Press the STEREO/MONO button to select Stereo and Mono as desired in case FM band is being selected. (If stereo signal
is too weak , “<<ST>>” icon will not appear, press this button to mono mode, the reception will be improved)
Note:
For better reception, FM wire antenna shall be fully untied and adjusted well.
This unit has a built-in antenna for AM, Locate the unit where you can obtain the best reception.
PRESET TUNING
1. Select the AM/FM band and tune to your desired station according to the normal tuning procedure.
2. Press the MEMORY/C-ADJ button, “P” will appear and flash in the LCD, Then use SKIP >>| or SKIP |<< button to change
the number where the station will be stored. (NO.1 to NO.15)
3. Store the current frequency by pressing MEMORY/C-ADJ button again when you get the desired number. (The “P” still
appears and will not flash.)
4. Repeat the same procedure to set other desired frequencies into Memory No.1 to NO.15
Remarks: A stored frequency can only be erased by storing another frequency in its place.
The unit can be preset up to 30 stations. (15 for AM and 15 for FM)
MEMORY RECALL
To recall the stored frequencies, Enter AM or FM band mode first, press REPEAT/MEM/RCL button first then use SKIP >>| or
SKIP |<< button to select 1 to 15 station as desired.
[NOTE:] As stored frequencies can only be stored for long time with the power
supplying, The station you stored will be lost and can not be recalled in case that you
cut off the AC power