Filter
Top Products
9-1
P/N: 4809628
©2003 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
05JUN03 v2.1 MusGT(4809628 v2.1)
Section 9
FINAL ASSEMBLY AND CHECK
W
e know that you are anxious to get out
and drive your new vehicle, but please
take a little bit more time to perform
these simple check-out steps.
A Inspect all wiring harnesses and electrical
connections. Make sure that all items are
properly routed, connected and secured. If
available, check grounds with an amp meter.
If the ground connection is suspect, connect
to the battery ground.
B. Check all hoses, lines, and fittings for prop-
erly secured connections..
C. Make certain all fasteners, brackets, and
clamps are installed and properly tightened.
D. Check serpentine accessory belt and super-
charger drive belts for proper tension and
alignment.
E. Cycle ignition key from “off” to the “on”
position 4-5 times.
F. Check the entire fuel system for possible
leaks.
G. Start engine and verify that the oil pressure
is within normal range.
H. Allow the engine to come up to normal
operating temperature.Turn the engine off.
I. Check the coolant level in the coolant recov-
ery bottle and top off as needed.
J. Check the following:
• Fluid Leaks
• Fluid Levels
• Belt Slippage
• Throttle Response
Now that the work is done, it’s time to enjoy.
PAXTON Automotive wants to thank you for
choosing our product, and wants to remind you that
the performance and response of your vehicle is
now different that what you are used to. Please
drive cautiously until you have grown accustomed
to the feel of your vehicle.
Please see the service manual included in your kit
for information on the service and maintenance of
your PAXTON Supercharger. Belt tightening,
troubleshooting, special tuning requirements, and
warranty information is also included in the
Service Manual.
9.1 FINAL ASSEMBLY AND CHECK