Filter
Top Products
N
E
14
HOW TO SET THE ALARMS
The WR601N has 2 alarms (alarm 1 and alarm 2). They
can
be used together or independently. The alarm icons
are
only displayed when alarm 1 or alarm 2 are active. No
icon(s) indicate that the alarm(s) have not been set.
Remember: From the Clock Display Mode, press MODE
to enter Calendar-Display and then again to set Alarm.
1. Press MODE once more to set Alarm 2.
Setting the Alarm:
1. With the clock displayed, press MODE until alarm
(1 or 2) display is entered.
NOTE The last set time of the alarm will be displayed.
If you have not set the alarm before, or if the alarm has
been disabled, the time will be displayed as [----].
2. Press and hold MODE for 2 seconds.
Remember: At any stage of the setting sequence, if no
entry is made after 9 seconds, the unit will automatically
return to the Clock Display Mode.
3. To enter the hour, press or until the desired
hour has been selected.
Remember:
Pressing and holding or will advance
digits in rapid sequence.
4.
When the desired hour is reached, press MODE to
advance select minutes. Press or to change
values.
5.
After selecting the minutes, press MODE or wait
9 seconds to exit Alarm-Setting Mode and return to
Clock Display Mode. The alarm ON icon ( ) for the
chosen alarm, will be shown to indicate that the
alarm is set and will sound at the set time.
When
an alarm goes off, it will sound for 1 minute, the
EL backlight will activate. Alarms 1 and 2 are identified
by
different sounds: Alarm 1 has 2 short bursts of sound
followed
by a pause which then repeats. Alarm 2 has 4
short
bursts of sound followed by a pause, which then
repeats.
Unless disabled, the alarms will sound for a total
of 1 minute before automatically turning o
ff.
DISABLING
AN ALARM
When
disabled, the respective alarm icon will not be
displayed
. A disabled alarm display is indicated by
blanks [----].
To disable alarm (1 or 2):
Press
MODE to enter alarm-1 or alarm-2 display followed
by
or .