Filter
Top Products
18
While the programmed sequence
plays, you can use to move
forward or
to move backward
in the sequence.
6. After the last programmed track
ends, the CD player stops. To stop
the CD before the end of the
sequence, press
STOP/CLEAR
.
Note:
You can replay, check, or add
to the programmed sequence within 2
minutes after play stops. Otherwise,
the CD player turns off and clears the
programmed sequence.
•
To replay the programmed se-
quence
, press
PLAY/PAUSE
.
•
To check the programmed se-
quence
, press
MEMORY/E-BASS
.
The display shows the number of
the first programmed track. Each
time you press
MEMORY/E-BASS
,
the display shows the number of
the next track in the sequence.
•
To add to the end of a pro-
grammed sequence
, repeatedly
press
MEMORY/E-BASS
until track
number
00
appears. Then follow
Steps 3 and 4.
To clear the programmed sequence
from memory, press
STOP/CLEAR
twice or open the CD compartment
door.
RESUME
You can set the CD player to remem-
ber the track it was playing when you
stopped the CD or it turned itself off.
That way, when you play the CD
again, the CD player resumes playing
at the beginning of that track.
To set the CD player to resume, set
OFF/RESUME/HOLD
to
RESUME
at any
time. Then, after you have pressed
STOP/CLEAR
to turn off the CD player,
you can simply press
PLAY/PAUSE
to
resume play.
To cancel resume play, set
OFF/
RESUME/HOLD
to
OFF
or open the CD
compartment.
Notes:
• If you press
STOP/CLEAR
very
close to the beginning or end of a
track, the CD player might play
the track before or after that track
instead when you press
PLAY/
PAUSE
. This is not a malfunction.
• If you install a different CD while
OFF/RESUME/HOLD
is set to
RE-
SUME
, play might not start from
Track 1 on the new CD. If this
happens, press
STOP/CLEAR
, set
OFF/RESUME/HOLD
to
OFF
, then
press
PLAY/PAUSE
again.
42-5075.fm Page 18 Thursday, August 12, 1999 1:03 PM