Filter
Top Products
Customized Alarm Playback
Setting the alarm
Select the message you
want to use as an alarm
playback by pressing the
button so
that the message No. is
displayed on the LCD (see
page 12).
Press and hold the
FOLDER/MENU button for
more than 1 second to
enter the Options mode
(see page 22).
In the Options mode,
select the [ALARM] setting
and press the
button to switch the
alarm [ON]. (Press the
FOLDER/MENU button.)
The LCD shows
The "hour" and "minute"
will start to blink. Set the
desired alarm time by
pressing the
/or
buttons
(see page 23).
Press the FOLDER/MENU button to continue through
the other options, or hit the STOP button to exit the
Options mode.
Alarm playback
At the specified alarm time, the recorder emits short
electronic beep tones.
Press any button while the beep tones are being emitted
to playback the message set for that time.
Press the STOP button to stop alarm playback.
The electronic beep tones stop automatically if no button
is pressed for 5 minutes after the beeping starts. The
message is not played back in this case.