Installation
24
• —Connector for a connectivity cable
• —Connector for the input device CU-8
• —Connector for the GPS receiver
• —Stereo audio output for a car radio system
• —Connector for the microphone MP-2
When you install the hands-free unit, ensure that the cables for the
microphone and loudspeaker reach the places where you intend to
mount these parts.
Do not mount the hands-free unit inside a metal housing or on a metal
surface because this will impair the Bluetooth connection between the
hands-free unit and the Bluetooth device that is connected to the car
kit. For an optimal connection, ensure that the distance between the
hands-free unit and a metal surface is over 4 mm (0.16 inch).
To mount the hands-free unit, use the hook and loop tape pads supplied
with the car kit in the same way as with the input device (see the figures
in Input device starting from p. 24). Detach the two pads from each
other. Attach the pad with the loops first: peel off the protective sheet
from the adhesive side, and attach the pad to the desired location in the
car. Ensure that the surface where you attach the pad is dry and free
from dirt and dust.
To attach the pad with the hooks, peel off the protective sheet from the
adhesive side, and attach the pad to the underside of the
hands-free unit.
Press the hands-free unit firmly onto the loop pad, and check that the
hands-free unit stays securely in place.
Input device
The input device should be located so that it is within easy reach of the
user. When installing the parts of the car kit ensure that none of them
interfere with or hinder the steering or braking systems or other controls
or systems used in the operation of the vehicle (for example, airbags).
Ensure that the input device cable reaches to the hands-free unit for
connection. The best location to mount the input device is horizontally