Filter
Top Products
7
OUTPUT POWER........................................................................................................... 75 watts RMS per channel into 4 Ohms load
OVERLOAD PROTECTION ...................... AMA™ (Automatic Maximum Amplitude) servo system limits the power amplifier input to
prevent clipping distortion that can damage speakers
FREQUENCY RESPONSE .......................................................................................................... 40 Hz to 20 KHz measured at 1 watt
TONE CONTROLS ................................................................................................. Bass: 100 Hz ±+/-10 dB; Treble: 10 KHz +/-10 dB
GRAPHIC EQUALIZER .................. 5 bands; 100 Hz, 350 Hz, 1 KHz, 3 KHz, and 8 KHz with FLI™ (Feedback Locating Indicators)
INPUT IMPEDANCE ....................................................................................................... Mic input: 2 K Ohms, Line input: 12 K Ohms
MAX GAIN ....................................................................................................................................... 86 dB mic input to speaker output
DISTORTION ................................................................................................................................Less than 0.8% THD at rated output
SIGNAL / NOISE RATIO ................................................................................................................................... 85 dB mic input typical
REVERB/DELAY ...........................................................................................................................DSP digital reverb and digital delay
SPEAKERS ..........................................................................................................Woofer 10" (254mm) and piezoelectric horn tweeter
AC POWER ........................................................................................................................... 120 VAC(60 Hz0 or 230 VAC (50/60 Hz)
DIMENSIONS ....................................................................................................... 27.6" x 15.75" x 23.4" (70.2 cm x 40 cm x 59.4 cm)
WEIGHT (assembled) .................................................................................................................................................. 59.4 lbs (27Kg)
MICROPHONE ..................................................................................................................................Unidirectional (cardioid) dynamic
SPECIFICATIONS
REAR PANEL CONTROLS & CONNECTIONS
(18) (16) (17) (19)
(16) FUSE HOLDER & POWER CORD CONNECTOR
This fuse holder contains an AC primary fuse. When this
fuse blows, replace it with the same type fuse, size and
power rating (see SPECIFICATIONS). If it continuously
blows, stop replacing the fuse and refer servicing to
qualified personnel. The cord connector is used to connect
the AC power source to your power amplifier.
(CAUTION: After checking the AC supply voltage, be sure
that the correct fuse is in the fuse holder.)
(17) AC VOLTAGE SELECT SWITCH
Before plugging in the power cord, check to see that the
unit is set for the proper voltage for your area: ~115V
(60Hz) or ~230V (50Hz).
(Note: use at the improper voltage can damage your unit
and void the warranty.)
(18) POWER SWITCH
Use this switch to power unit ON or OFF. Before turning on
this unit, verify connection to the proper voltage AC source,
check all connections and turn down the level controls of
equipment connected to the outputs.
(19) SPEAKER 1/4” OUTPUT JACKS
Connect to the left and right PSS-150 speakers.