Filter
Top Products
5
Apple Computer Users:
With both your computer and the dac25.3 powered on; connect the USB cable.
Go to System Preferences Sound Output choose the USB Audio DAC for
output. Close System Preferences. Launch iTunes.
Audio Out
The phones (headphone) output on the front is variable.
Connecting to the Mains - Plugging In
Special note: When using the USB input with your computer; the dac25.3 and
your computer should both be powered up. Your computer will recognize the new
hardware and self install the necessary drivers.
Connect the USB cable to the dac25.3 from your computer prior to launching your
audio player software: iTunes, Windows Media, Real Media, etc. If you haven't
followed this instruction, close your audio player software, then re-launch.
You will probably find that setting your audio player's and computer's volume to
max will sound best.
To avoid damage to the dac25.3, make sure it is plugged into an AC outlet
while connecting up or disconnecting either of the audio outputs. The dac25.3
has two sets of fixed audio outputs on the back. One single ended set labeled
RCA: R and L. And one balanced set labeled XLR: R and L. Connect the RCA or
XLR audio outputs to the correct audio inputs on your integrated amplifier,
preamplifier, or receiver.
NOT
Check that the Power Switch on the front of the dac25.3 is in the position.
Look at the slider on the back of the unit and confirm that it is
set for the correct voltage: (~115V USA/~230V Europe). Push the plug (IEC line
socket) of the power cable supplied with the dac25.3 into the socket on
back of the unit. Make sure it is pressed in firmly. Plug the other end of the
power cable into an AC wall outlet.
off
voltage selector
AC IN