Filter
Top Products
Configuring the DSP33 loudspeakers using a computer
29
If you choose Meridian surround controller the Start volume,
Tilt, and Bass options are controlled by the surround controller,
and will be greyed out in the Meridian Configuration program.
● Set the Speaker use to Normal for a main or surround
speaker, or Centre for a centre speaker.
If the speaker is close to a wall or corner, you can optionally
apply bass equalisation to adjust the frequency response to
compensate for its position.
● Use the appropriate Front or Centre speaker boundary
drop-down menu to choose the appropriate option:
Option What it means
Free Flat frequency response.
Boundary Speaker closer than 0.5m (2') to a wall.
Sub 1 or 2 Applies a second-order high-pass filter at
80Hz or 120Hz respectively for use with
an analogue subwoofer.
Corner Speaker closer than 0.5m (2') to a corner.
Changing the setup options
The next stage in editing the settings is to configure the general
Setup options.
To change the setup options
● Click the Setup icon in the left-hand panel of the Meridian
window.
The Setup options will be displayed:
● In the Controlled by section choose the appropriate option
for the system you are using.