Filter
Top Products
9
OPERATING INSTRUCTIONS (CONTINUED)
Press the POWER button to turn
the unit on.
1
Press the TUNING/CD Skip/
Search ❶ or ❷ button to
select a station (see Tuning note
below).
NOTE: If the FM band is selected
and you have tuned to an FM
Stereo station, the FM Stereo
indicator will light in the display.
1
2
4
Press the STOP (■)/BAND
button to select AM or FM.
NOTE: If you select the FM band,
be sure to extend the FM Wire
Antenna.
3
Press the TUNER Function
button; the RADIO indicator will
appear in the display.
2
Adjust the PRESET EQ ❶ and
VOLUME ❷ buttons as desired.
1
2
2
5
When you have finished listening,
press the POWER button to turn
the unit off.
6
Hints for Better Reception
FM - Make sure that the FM Wire Antenna is extended to its full length. You may have to vary the direction
of the antenna to find the strongest signal for each FM station.
AM - The AM ferrite bar antenna is located inside the unit. It may be necessary to turn the unit slightly so
that the internal antenna is pointing in the direction of the AM transmitter. You may have to experiment to
find the position that provides the strongest reception for each of your favorite AM stations.
LISTENING TO THE RADIO
TUNING:
MANUAL TUNING: Repeatedly press the TUNING/CD Skip/Search or to manually advance the
frequency in the display up or down until the desired frequency appears.
AUTOMATIC TUNING: Press and hold the TUNING/CD Skip/Search or until the frequency in the
display starts to scan, and then release the button; the tuner will search and then stop on the next strong
station it finds. Repeat this procedure until the desired frequency appears in the display.
MX4302.O/M.QXD 3/4/03 7:47 AM Page 9