Filter
Top Products
6
INSTALLATION
Unravel the AC cord and connect it to a
conveniently located AC outlet having 120V
and 60Hz only. The Clock Display will
illuminate and “12:00” will blink in the window.
NOTE: If the AC plug does not fit into a
nonpolarized outlet, do not file or cut the wide
blade.
If the AC cord is disconnected or if there is a
power failure, this electronic clock is designed
to continue operating internally (without showing the time on the Clock Display)
with a 9 volt battery (not included). To install the battery, remove the battery
compartment cover by pressing in on the tab, then connect the battery to the
terminals of the battery snap inside the compartment (use of an alkaline battery is
recommended). Replace the battery compartment cover.
Be sure to check the condition of the battery
periodically by disconnecting the AC cord and
connecting it again 2 or 3 minutes later. The preset
times should continue operating. If the present time
does not appear, it indicates the battery is dead or not
connected properly. The 9 volt battery will keep the
internal times accurately for approximately 30
minutes. If the power is restored after 30 minutes, the
times may need to be reset.
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the
battery compartment. Reversed batteries may cause damage to the device.
3. If the device is not to be used for a long period of time, remove the batteries to prevent
damage or injury from possible battery leakage.
4. Do not try to recharge batteries not intended to be recharged; they can overheat and
rupture. (Follow battery manufacturer’s directions.)
MC2842 O/M.QXD 6/20/03 10:39 AM Page 6