Filter
Top Products
IB-PDV702-WM-E-010807
1 Make sure all of the equipment is plugged back into the AC outlet.
2 Lift the LCD screen.
3 Slide the DVD player’s POWER switch to the ON position, the DVD logo (start-up picture) will
appear on the screen.
4 Turn on your TV and set it to DVD mode (please see box below), the DVD logo will appear on
your TV’s screen.
5 Press the OPEN button on the DVD player to open the disc door. Place a disc gently on the
tray with the label side up, make sure the disc is seated on the spindle by pressing down in
the center, close the door. The DVD player starts to read the disc’s table of contents (this
may take a few seconds).
6 Some discs will start playing automatically, and others will display the disc contents menu on
the screen. If the menu is presented, use the ( , , & ) direction buttons to highlight your
selection and press OK button to confirm.
7 Press the VOLUME + or VOLUME – button on the DVD player and on your TV’s remote
to adjust the volume level.
8 Fold down the LCD screen cover, the DVD player will continue to work, but the screen will
be dark.
9 To stop playback, press the STOP button.
10 To pause the playback, press the PLAY/PAUSE button on the DVD player. To resume
playback, press the PLAY/PAUSE button again.
NOTE 1: During play, press the STOP button once, the display will show “PRE STOP ”.
If you press the STOP button the second time, the display will show “STOP ”,
and now your system is in the full STOP mode.
NOTE 2: Leaving the set in the stop mode for a longer time will drain the battery the same
as during normal play, remember to shut off the power after use.
11 To skip to another track/chapter, press the NEXT or PREVIOUS button repeatedly
during playback.
12 To access the disc menu or title menu during DVD play, press the MENU or TITLE button
on the DVD player.
13 If you want to use other DVD play functions, please see pages 10-14.
14 Remember to shut off the player by sliding the POWER switch to the OFF position when
the movie finishes playing.
How to Find your TV’s Video Input Channel
Make sure you have made all the connections (see page 15), you may need to change
your TV’s video input mode to see the DVD player’s menu and movies, also double check
that both TV and player are plugged into the AC outlet.
1.Set your TV to the correct video input. For example, if you connect this player to the
VIDEO 1 input on your TV, switch your TV to video 1.
2.Switch your TV to the correct video input channel. The video input channel varies with
different TV brands and models, many TV remote controls have a TV/VIDEO button
which can be used to change to different video inputs and back to TV for normal
broadcast viewing, on some older TVs, you may need to press channel 3 or 4 on your
TV’s remote. Once you selected the correct channel, your TV will show the opening
DVD screen. For more details, please see your TV’s manual.
After all the connections have been done, please follow steps below to watch a DVD on your TV.
WATCHING A DVD ON YOUR TV
17
IB-PDV702-WM-E-010807.pmd1/30/2007, 7:12 PM18