Filter
Top Products
8
C. PROGRAMMING SEQUENCE
1. LCD Contrast Setting
2. Time Zone Setting
3. Manual Time Display
4. Year, Day & Date Setting
5. 12/24-Hour Setting
6. °C/°F Setting
7. Daylight Saving Time On/Off
D. FUNCTION BUTTONS
There are 3 function buttons located on the front of the projection
alarm and one on the top. The function buttons are labeled:
AL/HOUR, light direction icon, SET/+/MIN, and SNOOZE/ADVANCE
MODE/ADVANCE MODE (the top bar).
E. LCD CONTRAST SETTING
1. Hold down the “SET/+/MIN” button for 3 seconds, the time will
flash in the Time LCD.
2. Press and release the “SNOOZE/ADVANCE MODE” bar to
advance to the LCD Contrast Setting.
3. Press and release the “SET/+/MIN” button to move through the
different contrast settings. The LCD contrast can be set within 8
levels, from LC0-LCD7 (the default is LCD5).
4. Press and release the “SNOOZE/ADVANCE MODE” bar to
confirm the contrast selection and to advance to the Time Zone
Setting.
F. TIME ZONE SETTING
1. Hold down the “SET/+/MIN” button for 3 seconds, the time will
flash in the Time LCD.
2. Press and release the “SNOOZE/ADVANCE MODE” bar to
advance to the time zone selection.
Set Button (toggles between
indoor temp/hum and alarm
time. Also adjusts minutes in
time setting mode
Alarm Button (also adjusts
the hours in time setting
mode
)
Display Direction