Filter
Top Products
5
QUICK SET-UP GUIDE
Hint: Use good quality alkaline batteries
and avoid
rechargeable batteries.
1. Place the projection alarm and remote temperature
sensor 3-5 feet apart.
2. Batteries should not be installed into either unit for 15
minutes.
3. Place the batteries into the remote temperature sensor
first and then into the projection alarm.
4. DO NOT PRESS ANY BUTTONS FOR 15 MINUTES.
In this time the display and the sensor will begin to communicate
with each other. The display will show both the indoor
temperature/humidity and an outdoor temperature. If the station
does not display both temperatures and the indoor humidity after
the 15 minutes, please retry the set-up in the instructions above.
After both indoor and outdoor temperatures are displayed for 15
minutes you can place your sensor outdoors and set your time.
The remote sensor should be placed in a dry, shaded area. The
remote sensor has a range of 80 feet. Any walls that the signal has
to pass through will reduce distance of the range. An outdoor wall
or window has up to 20 feet of resistance and an interior wall has
up to 10 feet of resistance. Your distance plus resistance should
not exceed 80 feet in a straight line.
To complete the detailed set-up of your temperature station after
the 15 minutes have passed, please follow the steps beginning on
page 6.
NOTE: Direct rain will damage your remote temperature sensor. Fog
and mist, however, will not harm the sensor.