Filter
Top Products
16
Note: When setting up multiple units
it is important to remove the batteries
from all existing units in operation,
then to insert batteries first into all
the remote temperature/humidity
sensor units, and in numeric
sequence. Second, install batteries
into the indoor weather station.
Transmission problems will arise if
this is not done correctly and if the
total time for set-up exceeds 6
minutes.
1. It is necessary to remove the
batteries from all units currently in
operation.
2. Remove the battery covers to all
remote sensor units.
3. Place all remote sensor units in a
numeric sequential order.
4. In sequential order, install batteries
(follow the same battery installation
procedures seen in section “I” of the
Detailed Set-Up Guide) into the