Filter
Top Products
One person can remove the KID from its shipping
b
ox safely and easily.
1
. Open the shipping carton top flap. You see the
l
iterature pack containing:
1 Owner’s Reference
1 Warranty Registration Card
2. Remove the literature pack and the top layer of
foam to view:
1 KID
1 Accessory tray containing:
1 AC power cord
1 KID remote control
1
CR2025 lithium battery
1 iPod-device support(under the accessory tray)
3. Face the front of the shipping box and remove
the foam insert containing the AC power cord
by pulling the insert straight out of the box.
4. Set the remote and the AC power cord aside,
for later use.
5. Insert your hands below the left and right foam
i
nserts surrounding the KID.
6. Lift the KID with the foam inserts straight out
of the box.
7. Place the KID on a safe, clean work surface,
on its side, resting on a foam insert.
8. Remove the other foam insert.
9. Reposition the KID on the work surface, with
the remaining attached foam insert tilted up.
10.
Remove the second foam insert.
11. Remove the foam enclosing the component.
12. Place the KID on its feet, right side up, on the
work surface. You are now ready to affix the
iPod-device support to the chassis.
4. Insert your hands below the left and right foam
inserts surrounding the Papa Dock.
5. Lift the Papa Dock with the foam inserts
straight out of the box.
6. Place the Papa Dock on a safe, clean work
surface, on its side, resting on a foam insert.
7. Remove the other foam insert.
8. Reposition the Papa Dock on the work sur-
face, with the r
emaining attached foam insert
tilted up.
9.
Remove the second foam inser
t.
10. Remove the foam wrapper from the component.
12. Position the Papa Dock in the listening area.
UNPACK THE KID
One person can remove the Papa Dock from its
shipping box safely and easily.
1. Open the shipping carton top flap. You see a
protective cardboard sheet.
2. Remove the protective cardboard sheet to view:
1 Papa Dock
1 Accessory box containing:
1 AC power cord
1 12 VDC (12 V trigger) cable
1 T-10 Torx wrench
1 Literature pack containing the Owner’s
Refer
ence and W
ar
ranty Registration
Card
3. Remove the accessory box by pulling it
straight out of the box.
UNPACK THE PAPA DOCK
U
npacking the KID
Unpacking the Papa Dock
ITEMS NOT IN THE SHIPPING BOX. If any of the
items listed above are not included in the shipping
box, please contact your authorized Krell dealer or
distributor
.
PACKING MATERIALS. Save all packing materi-
als. To ship the KID or the Pap Dock in the future,
r
epack the unit in its original packaging to pr
event
shipping damage. For more information, see the
Return Authorization procedure, in the Service sec-
tion of the Krell website at www.krellonline.com.
4 Krell /Papa Dock
1
Insert the iPod-device into the KID Dock Connector
P
ower LED Color Guides
Operation
POWER
BASS
TREBLE
VOLUME
A
UX
INPUT
FIGURE 4 Inserting the iPod-device Into
the Dock Connector
4
1
When the KID or the Papa Dock are plugged into
AC power, connect the iPod-device:
1. Hold the iPod-device in both hands as shown
in the illustration above, using the iPod-device
support (1) as a guide.
2. Center the iPod-device connector against the
KID dock connector (4).
3. Push down on the top of the iPod-device
gently but firmly until its connector plugs into
the KID dock connector.
INSERT THE IPOD-DEVICE INTO
THE KID DOCK CONNECTOR
OPERATION
KID Power LED Color Guide. When the KID is
plugged into AC power, the power LED illuminates
as follows:
Red The KID is in stand-by mode.
Blue The KID is on, in the operational mode, in-
dicating that an iPod-device is connected.
Purple The KID is on, in the operational mode,
and an iPod-device is not connected.
When the iPod-device is connected to the KID,
you are ready to play music. When the KID is con-
nected to the Papa Dock and an iPod-device is
inser
ted into the KID dock connector, the KID pow-
ers on the Papa Dock.
1. Press the play key (33) on the remote.
2.
Adjust the volume (27) using the buttons on the
KID front panel or the keys on the remote.
Numerical values indicating the volume level
appear in the display window.
3. Adjust the bass tone control (25) using the
buttons on the KID front panel or the keys on
the remote. Numerical values indicating the
bass tone level appear in the display window.
4. Adjust the treble tone control (26) using the but-
tons on the KID front panel or the keys on the
r
emote. Numerical values indicating the treble
tone level appear in the display window.
5. Press the stop key (34) to end playback.
6. Press the play button or key to begin playback
again.
For a complete list of functions, see page 10.
Papa Dock Power LED Color Guide. When the
Papa Dock is plugged into AC power, the power
LED on the front panel illuminates as follows:
Red The Papa Dock is in stand-by mode.
Blue The Papa Dock is on, in the operational
mode, when the KID is connected to the
Papa Dock and the iPod-device is inserted
into the KID dock connector.
Kr
ell
/Papa Dock 9
7
8