Filter
Top Products
English
|
11
• If the fuse blows, first make sure the wires
aren’t touching to cause a short circuit,
then replace the old fuse with one with
the same rating.
• Connect the speaker wires correctly to the
terminals to which they correspond. The
unit may be damaged or fail to work if
you share the - wires or ground them to
any metal part in the car.
• After the unit is installed, check whether
the brake lamps, blinkers, wipers, etc. on
the car are working properly.
About CD players/disc changers
connected to this unit
If the CD player/ disc changer has the “O-N”
switch, set it to the “N” position.
The functions you can use and the
information that can be displayed may differ
depending on the models being connected.
Connecting the ISO Connector
The pin arrangement for the ISO connectors
depends on the type of vehicle you drive.
Make sure to make the proper connections
to prevent damage to the unit.
The default connection for the wiring
harness is described in 1 below. If the ISO
connector pins are set as described in 2,
make the connection as illustrated.
Please be sure to reconnect the cable as
shown 2 below to install this unit to the
Volkswagen vehicles etc.
1 (Default setting) The A-7 pin (red) of the
vehicle’s ISO connector is linked with
the ignition, and the A-4 pin (yellow) is
connected to the constant power supply.
A-7 Pin
(Red)
A-4 Pin
(Yellow)
Unit
Vehicle
Ignition cable
(Red)
Battery cable
(Yellow)
2 The A-7 pin (red) of the vehicle’s ISO
connector is connected to the constant
power supply, and the A-4 pin (yellow) is
linked to the ignition.
A-7 Pin
(Red)
A-4 Pin
(Yellow)
Unit
Vehicle
Ignition cable
(Red)
Battery cable
(Yellow)