Kenwood KDC-W3537 Portable CD Player User Manual


 
Troubleshooting Guide
32
|
English
Some functions of this unit may be disabled by
some settings made on this unit.
! Cannot switch to Aux source.
AUX is not turned on. <Built-in Auxiliary input
Setting> (page 25)
! Cannot display the user of System Q.
<Audio Control> (page 8) is not set.
! • Cannot set up the subwoofer.
• No output from the subwoofer.
• Cannot set up the low pass filter.
• Preout is not set to subwoofer. <Switching
preout> (page 22)
• <Subwoofer Output> (page 9) is not set to On.
! • Cannot register a security code.
• Cannot set up Display.
<Demonstration mode Setting> (page 25) is not
turned off.
! Cannot set up the Power-off timer.
<Security Code> (page 20) is not set.
! Cannot play audio files.
<CD Read Setting> (page 25) is set to "2".
What might seem to be a malfunction in your unit
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.
General
? The Touch Sensor Tone doesn’t sound.
The preout jack is being used.
The Touch Sensor Tone can’t be output from the
preout jack.
Tuner source
? Radio reception is poor.
The car antenna is not extended.
Pull the antenna out all the way.
The antenna control wire is not connected.
Connect the wire correctly, referring to the
section on <Connecting Wires to Terminals>
(page 29).
Disc source
? The specified disc does not play, but another one
plays instead.
The specified CD is quite dirty.
Clean the CD.
The disc is loaded in a different slot from that
specified.
Eject the disc magazine and check the number
for the specified disc.
The disc is severely scratched.
Try another disc instead.
Audio file source
? The sound skips when an Audio file is being
played.
The media is scratched or dirty.
Clean the media, referring to the CD cleaning of
the section on <Handling CDs> (page 5).
The recording condition is bad.
Record the media again or use another media.